緊急微波爐維修
全港即日上門
解決突發故障

現象：插電後燈不亮、按鍵無響應。
Symptom: No light, no response after plugging in.

原因：電源插座接觸不良、保險絲燒斷、電源線斷路。
Cause: Poor contact, blown fuse, broken wire.

處理：更換插座測試，非專業勿拆機內保險絲。
Solution: Change socket, DO NOT open machine by yourself.

現象：觸摸/機械按鍵無反應、反應遲鈍。
Symptom: Buttons not working or slow response.

原因：面板積油污、按鍵彈片老化、觸控板故障。
Cause: Oil dirt, aging parts, panel damage.

處理：關機斷電後用乾布清潔按鍵區，嚴重需更換面板。
Solution: Clean buttons, replace panel if needed.

現象：運行正常、有風聲，食物完全不熱。
Symptom: Runs normally but food not heated.

原因：磁控管損壞、高壓部件故障、高壓保險絲燒斷。
Cause: Magnetron damaged, high voltage parts failure.

處理：屬高壓部件，禁止自行拆修，立即聯繫我們。
Solution: HIGH VOLTAGE, DO NOT repair yourself.

現象：機器運行、加熱正常，盤子靜止不轉。
Symptom: Machine works but turntable stops.

原因：轉盤馬達損壞、滾輪脫落、傳動軸磨損。
Cause: Motor broken, roller loose, shaft worn.

處理：檢查滾輪是否移位、有異物卡阻，馬達損壞需更換。
Solution: Check roller, replace motor if needed.

現象：嗡嗡聲、異響、震動聲明顯變大。
Symptom: Abnormal buzzing, vibration noise.

原因：風扇卡異物、轉盤不平衡、機腳墊老化。
Cause: Fan blocked, unbalanced turntable, aging pads.

處理：清理風扇異物、擺平放穩轉盤。
Solution: Clean fan, place turntable properly.

現象：門已關嚴，機器判定門開啟，不能啟動。
Symptom: Door closed but machine shows open.

原因：門控開關鬆動/損壞、門扣變形、門縫異物。
Cause: Door switch loose, latch deformed, dirt blocked.

處理：清理門縫髒污，開關故障需專業維修。
Solution: Clean door gap, professional repair needed.

現象：運行一會就停機，反覆斷啟。
Symptom: Shuts down automatically during use.

原因：散熱不良、溫控保護、線路接點鬆動。
Cause: Poor ventilation, thermostat protection, loose wires.

處理：清理散熱口，保持四周通風。
Solution: Clean vents, keep ventilation space.

現象：觸碰機殼有輕微觸電感。
Symptom: Slight electric shock when touching case.

原因：接地不良、線路絕緣破損、油污導電。
Cause: Poor grounding, wire damage, oil conduction.

處理：檢查地線，清潔油污，故障未排除立即停用。
Solution: Check ground wire, stop using immediately.

現象：食物一邊燙一邊冷。
Symptom: Food partially hot, partially cold.

原因：轉盤卡滯、微波反射不均、腔體積油。
Cause: Turntable stuck, uneven microwave reflection, oil dirt.

處理：清潔爐腔、確保轉盤正常轉動。
Solution: Clean cavity, ensure turntable works.

現象：使用中冒煙、有焦糊味。
Symptom: Smoke and burning smell during use.

原因：積油過多、食物燒焦、線路燒蝕。
Cause: Excessive oil, burnt food, wire burned.

處理：立即斷電停機，深度清潔；持續冒煙立即送修。
Solution: Power off immediately, clean deeply, send for repair.